![background image](http://html1.mh-extra.com/html/hilti/dx-450/dx-450_manual_2135896033.webp)
*2338162*
2338162
English
29
1. Flip the cycling lever forward
(1)
.
2. Pull the tensioning lever forward
(2)
and unhook the advancer lever.
3. Unscrew the base plate
(3)
and remove the base plate
(4)
.
4. Pull the fastener guide out of the base plate
(5)
.
Check the stop ring for damage. If the stop ring is damaged, disengage the friction ring
(6)
and
remove the stop ring
(7)
.
5. Allow the piston guide to slide out of the housing
(8)
.
6. Use the rod supplied to push the piston out of the piston guide
(9)
.
8.3.2 Checking piston and stop ring
WARNING
Risk of injury!
A faulty stop ring or piston or a faulty base plate leads to an increased risk of malfunctions.
▶
Check the stop ring and piston for wear and replace them if damaged.
▶
Do not tamper with or modify the piston.
▶
Do not attempt to repair a faulty piston yourself, for example by grinding the tip.
1. The piston must be replaced in the following cases:
▶
The piston is broken.
▶
The piston is badly worn or chipped (e.g. a segment of more than 90° of the circumferential
ring-shaped elevation at the piston tip broken away)
▶
The piston is bent (check by rolling the piston on a smooth, flat surface).
2. The stop ring must be replaced in the following cases:
▶
The stop ring is clearly deformed, broken or detached.
▶
The snap ring is broken, detached or missing.
▶
The stop ring no longer holds on the fastener guide.
Never use a worn or damaged piston and do not tamper with or modify the piston.
Comply with the information on wear criteria applicable to important tool components in these
operating instructions → page 29.
8.3.3 Criteria for replacement of wear parts
Piston and stop ring wear criteria
Status
Illustration showing example
Annotation
Worn
Always replace the
piston and stop ring
together.
Signs of chipping at the tip / face
of the piston.
The piston has worn an impres-
sion into the stop ring, the stop
ring is deformed.
8.3.4 Cleaning and oiling fastening tool
Use only
Hilti
spray. The use of other lubricants can cause malfunctions or damage the fastening tool.
Apply the
Hilti
spray only as a thin film. It is not permissible for beads to form. For example, after
applying the
Hilti
spray, rub the oiled surface down lightly with the cloth supplied with the spray.
Make sure that no oil makes its way into the cartridge chamber!
1. Disassemble the fastening tool. → page 28
Summary of Contents for DX 450
