![background image](http://html.mh-extra.com/html/hilti/dd-af-ca-l/dd-af-ca-l_original-operating-instructions_2134971029.webp)
*2289378*
2289378
English
23
The following preconditions must be fulfilled:
• The auto-feed unit is mounted correctly on the drill stand.
• The auto-feed unit and the diamond core drilling machine are paired and the Bluetooth connection
is established.
• The continuous-running lock on the diamond core drilling machine is activated.
• The drilling operation has been started by pressing the
button.
1. A "Surface search in progress" message appears on the display.
▶
The drilling system searches for the surface of the material to be drilled.
▶
The drilling system detects the surface.
2. The drilling system switches the cooling water supply on.
3. The drilling system starts drilling in hole-starting mode.
4. The drilling system switches to normal mode and carries out the drilling operation.
▶
The current drilling depth is shown on the display.
5. On detecting a break-through or a depth-gauge stop, the drilling system returns to its initial position.
▶
The diamond core drilling machine switches off.
▶
The cooling water supply is shut off.
The drilling depth displayed is the totaled drilling depth since the last break-through detection
without depth-gauge stop detection. Drilling progress between two consecutive detections equals
the total depth of a drillhole.
The information is displayed until a new drilling operation after a break-through detection or a
depth-gauge stop detection is started.
6.2
Viewing drilling statistics (during and after the drilling operation)
In
CUT-ASSIST
mode, the analysis data of the diamond core drilling machine are supplemented by analysis
data of the auto-feed unit. You can call up the analysis data in the following situations:
• During the drilling operation.
• After the drilling operation (
EMERGENCY STOP
switch pressed)
Call up the analysis data by pressing the
button. To browse through the analysis data, repeatedly press
the
button.
The read-out disappears automatically after 30 seconds.
Analysis data of the auto-feed unit
Reset the
'Last Job' counter:
You can manually reset all day counters (identifiable by the
symbol)
of the available analysis data to 0:
• Press the
button and hold it down for at least 5 seconds.
You can call up the following analysis data on the auto-feed unit:
Display
Explanation
This shows you the operating modes (hand-held, rig-based, with auto-
feed unit) in which the diamond core drilling machine was operated
(figures are percentages since the last reset of the counter).
This shows you how deep the drilling system has drilled.
•
shows depth drilled in
AF-CA
mode since the last reset.
•
shows the total depth the diamond core drilling machine has
drilled in
AF-CA
mode.
You can toggle the unit of measure (metric or imperial) used for the
readings. Press the
button and hold it down for 3 seconds.
Summary of Contents for DD AF-CA L
