Hilti DAG 125-S, Operating Instructions Manual, Page: 23 / 271

Obligation signs
Wear eye
protection
Wear a hard
hat
Wear ear
protection
Wear
protective
gloves
Wear
breathing
protection
Symbols
Read the
operating
instructions
before use
Return waste
material for
recycling.
Volts Amps
Alternating
current
Rated speed Revolutions
per minute
Revolutions
per minute
Diameter Double
insulated
Location of identification data on the power tool
The type designation, item number, year of manufacture
and technical status can be found on the type identific-
ation plate on the machine or tool. The serial no. can
be found on the underside of the motor housing. Make
a note of this data in your operating instructions and
always refer to it when making an enquiry to your Hilti
representative or service department.
Type:
Serial no.:
2 Description
2.1 Use of the product as directed
The power tool is designed for cutting, grinding and brushing metal or mineral materials (concrete, stone, etc.) without
use of water. Use of a guide carriage is mandatory for cutting stone.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
Working with metals: Cutting, rough grinding, fine grinding, brushing
Working with mineral materials: Cutting and slitting using the corresponding dust removal hood (DC-EX), grinding
using the corresponding dust removal hood (DG-EX).
Use only grinding discs, cutting discs and other accessories that are approved for use at a speed of at least 11000
/min at 125 mm diameter.
Use only synthetic resin-bonded, fiber-reinforced grinding or cutting discs or diamond cutting discs approved for use
at a peripheral speed of 80 m/sec.
The power tool may be used only for dry cutting or grinding.
Cutting or grinding materials containing asbestos is not permissible.
When grinding stone, a vacuum cleaner equipped with a stone dust filter, e.g. a suitable Hilti vacuum cleaner, must be
used.
en
18
DCG 125-S / DAG 125-S / DAG 125-SE, Art. Nr.382617/A3, 05.03.2013
Printed: 08.07.2013 | Doc-Nr: PUB / 5069490 / 000 / 01