![background image](http://html1.mh-extra.com/html/hilti/bx-3/bx-3_original-operating-instructions_2135876031.webp)
English
25
▶
Store the tool and batteries in a place that is as cool and dry as possible.
▶
Never store batteries in direct sunlight, on heating units or behind a window pane.
▶
Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶
Check the tool and batteries for damage before use after long periods of storage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact
Hilti
Service.
Trouble or fault
Possible cause
Action to be taken
The spring element is not ten-
sioned; no status indication.
The battery is empty.
▶
Change the battery.
The battery is not fitted correctly.
▶
Fit the battery. → page 21
There is a delay before the
spring mechanism is ten-
sioned, the status indicator
flashes blue and a signal tone
is emitted simultaneously; the
status indicator then lights
blue for 6 minutes.
The magazine is empty.
▶
Load the magazine. → page 21
The spring element is not ten-
sioned, the status indicator
flashes green and 1 battery
charge status LED flashes.
The battery is empty.
▶
Change the battery.
Battery temperature too low.
▶
Allow the battery to warm up
slowly to room temperature.
The spring element is not re-
tensioned, the status indica-
tor flashes green and 4 bat-
tery charge status LEDs flash.
The fastening tool has overheated.
▶
Allow the fastening tool to cool
down.
The spring element is not ten-
sioned and the status indica-
tor flashes red.
The fastener guide is not fitted
correctly.
▶
Insert the fastener guide.
The spring element is not ten-
sioned and the status indica-
tor lights red.
System fault.
▶
Remove the battery. → page 21
▶
Fit the battery. → page 21
The fastener guide cannot
be pressed in and the status
indicator lights green.
The magazine is empty.
▶
Load the magazine. → page 21
The nail pusher is jammed.
▶
Remove the nail strips from
the magazine and clean the
magazine.
Nail jammed in the fastener guide.
▶
Release the jammed nail.
The fastener guide is jammed
in the pressed-in state.
Dirt between the fastener guide
and the nosepiece.
▶
Clean the inside of the nose-
piece. → page 24
Printed: 26.09.2017 | Doc-Nr: PUB / 5376263 / 000 / 00
Summary of Contents for BX 3
