![background image](http://html.mh-extra.com/html/hilti/ag-180-20-d/ag-180-20-d_original-operating-instructions_2135580030.webp)
24
Français
2075442
*2075442*
10
Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact
Hilti
Service.
10.1
Troubleshooting
Trouble or fault
Possible cause
Action to be taken
Product does not start.
Interruption in the electric supply.
▶
Plug in another electric tool or
appliance and check whether it
works.
The supply cord or plug is defec-
tive.
▶
Have the supply cord and plug
checked by a trained electrical
specialist and replaced if
necessary.
The carbon brushes are worn.
▶
Have the power tool checked by
a trained electrical specialist and
the carbon brushes replaced if
necessary.
The restart interlock is activated af-
ter an interruption in the electricity
supply.
▶
Switch the product off and then
on again.
Product does not develop full
power.
The extension cord conductor
cross section (gauge) is inade-
quate.
▶
Use an extension cord with
an adequate conductor cross
section.
11
Disposal
Most of the materials from which
Hilti
tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to
Hilti
for recycling. Ask
Hilti
Service or your Hilti representative
for further information.
▶
Do not dispose of power tools, electronic equipment or batteries as household waste!
12
RoHS (Restriction of Hazardous Substances)
Click on the links to go to the table of hazardous substances: qr.hilti.com/r2328153.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
13
Manufacturer’s warranty
▶
Please contact your local
Hilti
representative if you have questions about the warranty conditions.
Mode d'emploi original
1
Indications relatives à la documentation
1.1
À propos de cette documentation
• Lire intégralement la présente documentation avant la mise en service. C'est la condition préalablement
requise pour assurer la sécurité du travail et un maniement sans perturbations.
• Bien respecter les consignes de sécurité et les avertissements de la présente documentation ainsi que
celles figurant sur le produit.
• Toujours conserver le mode d'emploi à proximité du produit et uniquement le transmettre à des tiers
avec ce mode d'emploi.
Summary of Contents for AG 180-20 D
