21
Chapter 2 Installing and Removing an Expansion Module
|
Hillstone
Hillstone SG-6000 X-Series Expansion Modules Reference Guide
Figure 2-2: Installing an Expansion Module (SCM as an example)
6.
Tighten the screws clockwise.
Note:
The tray is installed in each expansion slot at the factory, and you can install the
half width modules by taking the above steps. When installing the full width modules
(such as SSM-200, QSM-200, IOM- -200, IOM- and IOM-8SFP+),
you should remove the tray and install the modules by taking the above steps.
Removing an Expansion Module
Removing an Expansion Module of SG-6000-X10800
Each module of SG-6000-X10800 has the similar installation and replacement
procedure.
To remove an expansion module, take the following steps:
1.
Wear the ESD wrist strap around your bare wrist and connect the other end to
an ESD point on the chassis.
2.
Identify the expansion module you want to remove, and loosen the screws on
that module counter-clockwise till it pops up.
3.
Rotate the lever to outside till the lever head is out of the expansion slot, as
shown below.