7 Operation
55000-00012_002_01 – 1695233 – 25/01/2018
38
Figure 16
7.6
Switching the light head on / off
The ceiling-mounted version of the lighting system is
connected to the power supply via a fixed connection.
Establishing the voltage supply
Ceiling and wall-mounted version with fixed connection:
• Switch on the master switch in the examination room.
Wall-mounted version and mobile stand version with cable
connection:
• Connect the power supply with the mains cable ( see
Chapter 6.1.4, Chapter 6.1.6).
→ The power supply of the device is in Standby mode.
Switching on the light head
• Press the ON / OFF bu on ① on the control panel ④.
→ The light head starts to light up.
Switching off the light head
• Press the ON / OFF bu on ① on the control panel ④.
→ The light head goes out.
Disconnecting the voltage supply
Ceiling and wall-mounted version with fixed connection:
• Switch off the operating theatre master switch.
→ The lighting system is disconnected from the power
supply.
Wall-mounted version and mobile stand version with cable
connection:
• Disconnect the mains plug (see Chapter 6.1.4, Chapter
6.1.6).
→ The lighting system is disconnected from the power
supply.
7.7
Setting the light intensity
The intensity of illumination of the light head can be adjusted
in three stages:
– 30 %
– 60 %
– 100 %
The light intensity which is currently set is indicated by the
illuminated LED.
Reducing the light intensity:
• Press key ② on the control panel ④.
→ The LED for the currently set light intensity lights up.
Increasing the light intensity:
• Press key ③ on the control panel ④.
→ The LED for the currently set light intensity lights up.
