4.4 Tie Rod Assembly
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 8
TRANS
l
LIFT
TM
Resident Stand Assist Service Manual (man173)
4
4.4
Tie Rod Assembly
Tools required:
Socket head wrench
Removal
CAUTION:
Lay a sheet or other protective cloth on the floor before turning the unit
on its back. Failure to do so could result in equipment finish damage.
1. Lay a sheet or other protective cloth on the floor. Place the unit on its back.
2. Remove the base cover (refer to procedure 4.3).
3. Remove the hex nut (A) securing the tie rod assembly (B) to the spreader
shaft subassembly (C) (see figure 4-4 on page 4-8).
Figure 4-4. Tie Rod Assembly
4. Remove the hex nut (D) securing the tie rod assembly (B) to the leg
subassembly (E).
5. Remove the tie rod assembly (B).
m173_012
