Use the Patient Pendant
Install and Remove the
Patient Pendant
• Install—
1. Connect the patient pendant
to the bed at one of the
connectors on either side of
the bed.
2. Put the pendant into position
next to the opening in the
head end siderail.
3. Set the top edge of the
pendant into the siderail so it engages the upper section of the siderail.
4. Turn the lower edge of the pendant in until it clicks into place inside the siderail.
• Remove—Gently pull on the lower edge of the pendant until it pops out of the siderail.
Raise and Lower the Head and Knee Sections
Head Section
WARNING:
To help prevent inadvertent bed movement, make sure the casters are locked
before raising or lowering the head section. Failure to do so could result in patient
injury, personal injury, or equipment damage.
• Raise—Press and hold the Head Up control until the head section is at the applicable
angle.
• Lower—Press and hold the Head Down control until the head section is at the
applicable angle.
NOTE:
When the head section is articulated, the automatic contour function also articulates the
knee section.
Knee Section
• Raise—Press and hold the Knee Up control until the knee section is at the applicable
angle.
• Lower—Press and hold the Knee Down control until the knee section is at the
applicable angle.
16
