Engine Starter Power Pack
83-6060-12
If faults cannot be remedied, contact the
Helpline
on
020 83916767
1 ROEBUCK PLACE, ROEBUCK ROAD, CHESSINGTON, SURREY KT9 1EU
HILKA TOOLS
GUARANTEE
This product is guaranteed for domestic use for a period of 12 months against faulty manufacture or materials. This
guarantee does not affect the statutory rights of the consumer. If in the event of any problem occurring please
contact our Helpline at the number above for advice. This product is not guaranteed for HIRE purpos
83-6060-12 - Issue 1 - R.W. 28-09-07
-8-
MAINTENANCE
Maintenance
Always inspect the jumpstart before use to ensure the cables are in good condition and
the clamps are clean and free from corrosion. Have them replaced if any damage is
apparent. Keep clean by wiping with a dry cloth. Do not use solvents as a cleaning agent.
12Volts output socket
A built-in reset device will shut off the power when the jumpstart overloads.
This device will reset after a few minutes and the jumpstart will resume normal
service condition again.
Replaceable fuse
The fuse will be blown out in the case of overloading.
Unscrew the fuse cap (in position of item 4) and replace with a new 2A fuse,
the Jumpstart will then resume to work.
NOTE:
DISCONNECT APPLIANCE BEFORE YOU CARRYING OUT ANY
MAINTENANCE
WARNING:
● Do not use the output socket and jumpstart at the same time.
● The output can be as high as 13 volts after the jumpstart has been fully charged,
consult your appliance handbook to ensure it is safe to operate.
● Do not allow the battery to be completely discharged as the charger can not
recover a deeply discharged battery.
Part No: 41156
