94
User Manual of PanoVu Series Network Camera
Figure 7-2 Time Settings
Configuring Time Synchronization by NTP Server
Steps:
(1) Check the radio button to enable the
NTP
function.
(2) Configure the following settings:
Server Address:
IP address of NTP server.
NTP Port:
Port of NTP server.
Interval:
The time interval between the two synchronizing actions by NTP server. It can be set
from 1 to 10080 minutes.
Figure 7-3 Time Sync by NTP Server
(3) You can click
to check whether the confguration is succeeded.
Note:
If the camera is connected to a public network, you should use a NTP server that has a time
synchronization function, such as the server at the National Time Center (IP Address:
210.72.145.44). If the camera is set in a customized network, NTP software can be used to
establish a NTP server for time synchronization.
Configuring Time Synchronization Manually
Steps:
(1) Check the
Manual Time Sync
radio button.
(2) Click
to set the system time from the pop-up calendar.
(3) Click
to save the settings.
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]