ERT-F2xxx DVR User Manual
UM ERT-F2xxx 030118NA
3
Mandatory Electrical Requirements
Hikvision requires the following conditions and equipment for all of its electronic equipment:
•
Grounding
Ensure good conductivity for all ground paths; examine ground path contact surfaces for defects, dirt,
corrosion, or non-conductive coatings that may impede conductivity. Repair or clean contact surfaces as
necessary to assure good metal-to-metal contact. Ensure fasteners are properly installed and tightened.
•
Electrical Wiring
Ensure your outlets are properly wired. They can be checked with an electrical outlet tester.
•
Surge Suppressor (Required)
Hikvision is not responsible for any damage to equipment caused by power spikes in the electrical power
grid. Use of a surge suppressor meeting the following specifications is mandatory for all Hikvision
electronic equipment:
•
Specifications
˗
Listed by Underwriter’s Laboratories, meeting the UL 1449 Voltage Protection Rating (VPR)
˗
Minimum protection of 1,000 joules or higher
˗
Clamping voltage of 400 V or less
˗
Response time of 1 nanosecond or less
•
Usage
˗
Surge suppressors must not be daisy chained with power strips or other surge suppressors
•
Maintenance
˗
Replace after a serious electrical event (e.g., lighting blew out a transformer down the street)
˗
Replace yearly in storm-prone areas
˗
Replace every two years as routine maintenance
Safety Instructions
Proper configuration of all passwords and other security settings is the responsibility of the installer and/or
end-user.
In the use of the product, you must be in strict compliance with the electrical safety regulations of the nation
and region. Please refer to technical specifications for detailed information.
Input voltage should meet both the SELV (Safety Extra Low Voltage) and the Limited Power Source with 100 to
240 VAC, 48 VDC or 12 VDC according to the IEC60950-1 standard. Please refer to technical specifications for
detailed information.
Do not connect several devices to one power adapter as adapter overload may cause over-heating or a fire
hazard.
Please make sure that the plug is firmly connected to the power socket.
If smoke, odor, or noise rise from the device, turn off the power at once and unplug the power cable, and then
please contact the service center.
Preventive and Cautionary Tips
Before connecting and operating your device, please be advised of the following tips: