Panic Alarm Station
User Manual
19
management page. The following describes how to add devices through IP/Domain Name. For
more information, see iVMS-4200 Client Software User Manual.
Steps
1. On the Device page, click Add.
2. Select IP/Domain as the adding mode, edit the device information, including Name, Address,
Port, User Name, and Password.
3. Click Add to add the device.
Edit the device network parameters so that the device IP address is in the same subnet as the
computer IP address.
You can edit the network parameters through the SADP software, or the client software. The SADP
software is taken as an example for explanation.
Steps
1. Run the SADP software, check the activated device, and edit the IP Address, Subnet Mask,
Gateway and other parameters in the Modify Network Parameters list on the right.
If check Enable DHCP, the device can automatically obtain network parameters.
2. Enter the activation password, click Modify, and the prompt Modify parameters is successful
indicate that the settings take effect.
Network Configuration
Configure network mode, IP address, NIC and NIC type, subnet mask, gateway, MAC address, MTU
settings, and port No. for device.
Before You Start
Make sure the cable of the device is connected.
Steps
1. Click
to enter the Remote Configuration page, go to Network → General.
