DS-6700HQHI-SATA Series Encoder Quick Start Guide
16
1.
Make sure the encoder is connected with the camera/dome which supports PTZ function. Connect the
R+
and
R
-
terminals of the pan/tilt unit or speed dome to RS-485 T+ and RS-485 T- terminals of the
DS-6700HQHI-SATA respectively.
2.
The baud rate, PTZ control and address configured in the
RS-485 Settings
interface
(
Remote
Configuration > Serial Port Settings > 485 Serial Port
) must be the same with the parameters of the
connected pan/tilt unit or speed dome.
Operating PTZ Control
In live view mode, you can use the PTZ control buttons to realize pan/tilt/zoom control of the camera lens.
There will be 8 directional buttons (up, down, left, right, upper left, upper right, bottom left, bottom right) on the
display window when the mouse is located in the relative positions.
Click on the directional buttons to control the pan/tilt movement.
Figure 4. 4
PTZ
Click the zoom/iris/focus buttons to realize lens control.
Refer to the following table for description of PTZ control buttons:
Table 4. 1
Button Description
Button
Description
Zoom in/out
Focus near/far
Iris open/close
Light on/off
Wiper on/off
Adjust speed of pan/tilt movement
(level 1to 7 is selectable)
4.4
Recording
Before you start
Make sure the Encoder is connected with HDD (for DS-6700HQHI-SATA) or network disk, and the HDD or
network disk has been initialized for the first time to use.
Two recording types can be configured: Manual and Scheduled. The following section introduces the
configuration of scheduled recording.