Quick Operation Guide of DS-6600HFHI (/L) Series HD Audio/Video Encoder
3
Item
Description
1
PWR
Power LED indicator: 1. Lights in red when the device is working; 2. Does not
light when the device is powered off.
LINK
LINK LED indicator: 1. Normally lights in green when the network connection
is functioning properly; 2. Does not light when the network connection is
abnormal.
Rx/Tx
Rx/Tx LED indicator: 1. Does not light when the network is not connected; 2.
Blinks in green when the data is transmitting / receiving; 3. Blinks at higher
frequency when the data for transmitting / receiving is larger.
2
HD-SDI IN
HD-SDI video input.
HD-SDI OUT
HD-SDI video loop output.
3
YPbPr Interface
YPbPr video input.
4
HDMI Interface
HDMI video input.
5
OPT Interface
OPT video input. Connect to camera with fiber optic interface.
6
VGA Interface
VGA video input.
Note:
Each of the HD-SDI, HDMI, VGA, OPT and YPbPr video input interfaces must be connected
independently.
Rear Panel
Interface
Connection
1
RESET
Restore the factory default settings by holding the
RESET
button for 15 seconds
after power is turned on.
2
AUDIO IN
BNC connectors for audio input.
3
LINE IN
3.5mm two-way audio interface for connection to active pick-up, microphone,
etc.
4
AUDIO OUT
3.5mm audio output interface for connection to audio output device, e.g.,
loudspeaker, etc.
5
LAN
10 M/100 M/1000 Mbps self-adaptive UTP Ethernet interface.
6
RS-232
Serial interface for configuration of device’s parameters or used as transparent
channel.
7
RS-485
RS-485 serial interface for connection to pan/tilt unit, speed dome, etc.
ALARM IN
Relay alarm input.
ALARM OUT
Relay alarm output.
8
12V DC
12V DC power supply
9
GND
Grounding