Quick Operation Guide of DS-6600HFHI (/L) Series HD Audio/Video Encoder
11
2.
Connect the
R+
and
R
-
terminals of the pan/tilt unit or speed dome to RS-485 T+ and RS-485 T- terminals of
the DS-6600 respectively
.
3.
The baud rate, PTZ control and address configured in the
RS-485 Settings
interface
(
Remote
Configuration > Serial Port Settings > 485 Serial Port
), must be the same with the parameters of the
connected pan/tilt unit or speed dome.
In live view mode, you are allowed to use the PTZ control buttons to realize pan/tilt/zoom control of the camera
lens.
There will be 8 directional buttons (up, down, left, right, upper left, upper right, bottom left, bottom right) on the
display window when the mouse is located in the relative positions.
Click on the directional buttons to control the pan/tilt movement.
Click the zoom/iris/focus buttons to realize lens control.
Refer to the following table for description of PTZ control buttons:
Table 1-1
Description of PTZ Control Panel
Button
Description
Zoom in/out
Focus near/far
Iris open/close
Lighter on/off
Wiper on/off
Adjust speed of pan/tilt movement
(level 1~ 7 is selectable)
Recording
Before you start
Make sure the Encoder is connected with network disk, and the network disk has been initialized for the first time
to use.
Two recording types can be configured: Manual and Scheduled. The following section introduces the
configuration of scheduled recording. For manual recording, please refer to the
User Manual of DS-6600FHI L).
Steps:
1.
Click the
Remote
C
onfiguration> Camera Settings> Record Schedule
to enter the Record Schedule
settings interface.