HIKVISION DS-6300DI-T, User Manual

Page: 26 / 50

User Manual of DS-6300DI-T Decoder
25
Figure 4.20 Check Device Information
4.2.2 Configuring Time Settings
You can set the time for the decoder in the Time Settings interface.
Steps:
1.
Click Configuration > Time Settings to enter the following interface:
Figure 4.21 Configure Time Settings
2.
Configure the time synchronization by NTP server or by manually.
 Configuring Time Sync by NTP Server
A Network Time Protocol (NTP) Server can be configured on your device to ensure the accuracy of system
date/time.
If the device is connected to a Dynamic Host Configuration Protocol (DHCP) network that has time server
properties configured, the camera will synchronize automatically with the time server.
Enable the
NTP function by checking the checkbox, and configure the following settings:
NTP Server: IP address of NTP server.
NTP Port: Port of NTP server.
Figure 4.22 Configure Time by NTP
Note : If the device is connected to a public network, you should use a NTP server that has a time synchronization