User Manual of Thermal Network Positioning system
© Hikvision
52
5.
Click
tab to enter the arming schedule setting interface. The time
schedule configuration is the same as the settings of the arming schedule for motion
detection. Refer to
Section 5.2.1 Configuring Motion Detection
6.
Click
tab to select the linkage method taken for the audio input
exception, Notify Surveillance Center, Send Email, Trigger Alarm Output and Trigger
Recording are selectable. Refer to
Section 5.2.1 Configuring Motion Detection
7.
Click
to save the settings.
5.3.2
Configuring Fire and Smoke Detection
Purpose:
When you enable this function and fire source or smoke is detected, the alarm actions will
be triggered. You can set different detection mode, fire source zoom mode, and so on.
Steps:
1.
Enter Configuration>Advanced Configuration>System>VCA Resource Type to select
Fire and Smoke Detection as VCA Resource Type.
2.
Enter the fire and smoke detection interface:
Configuration > Event > Smart Event > Dynamic Fire and Smoke Detection
Figure 5-21
Fire and Smoke Detection
3.
Check the checkbox of Enable Fire and Smoke Detection to enable the fire and smoke
detection function.