User Manual of IR Speed Dome
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
33
Steps:
(1)
Move the cursor to
EDIT ZONE
and click
IRIS+
button to enter the
edit mode.
(2)
You can see
SET LEFT LIMIT
on the screen. Click the direction buttons to set the left limit
stop.
(3)
Follow the prompts on the screen to set the right limit, up limit and down limit.
(4)
Click
IRIS+
button to save the settings and exit.
4.
Set the zone status and scan status.
ZONE STATUS:
The zone status just indicates the current status of the zone.
SCAN STATUS:
You can set the scan status to
ON/OFF
to enable/disable the scanning in the
zone.
Note:
ZONE STATUS
is not editable. After you edited the zone, it will switch to
ON
automatically;
if you delete the zone, the
ZONE STATUS
will switch to
OFF
.
5.
Clear the zone settings.
Move the cursor to
CLEAR ZONE
, click
IRIS+
to clear all the settings of the current zone, and click
IRIS+
again to confirm the settings and exit.
3.4.7
Clearing PTZ Control Settings
Purpose:
You can clear all user-defined PTZ control settings, including presets, patrols, patterns, zones and
time tasks. You can also clear privacy masks on this menu.
Steps:
1.
Enter the
CLEAR SETTINGS
menu:
MAIN MENU > DOME SETTINGS > CLEAR SETTINGS
CLEAR SETTINGS
CLEAR ALL PRESETS
CLEAR ALL PATROLS
CLEAR ALL PATTERNS
CLEAR ALL BLANKS
CLEAR ALL ZONES
CLEAR ALL TIME TASKS
<DIAGNOSTICS>
BACK EXIT
Figure 3-20
Clear Dome Settings
2.
Move the cursor to each item, e.g., CLEAR ALL PATTERNS, and click
IRIS+
to enter the
corresponding submenu. Click
IRIS+
again to confirm the settings and exit.
On
DIAGNOSTICS
submenu, you can see the self-diagnostics information of the speed dome. For
more details, please refer to the table below.
/R&DOO
ZZZFFWYLUHODQGLH
VKRS#FFWYLUHODQGLH