4
English
21. The use of the battery in a cold condition (below 0 degree
Centigrade) can sometimes result in the weakened
tightening torque and reduced amount of work. This,
however, is a temporary phenomenon, and returns to
normal when the battery warms up.
22. The pushing button can not be switched while the power
tool is turning. To switch the pushing button, stop the
power tool, then set the pushing button.
23. Install securely the hook. Unless the hook is securely
installed, it may cause an injury while using.
When electing to carry the tool hooked to your hip belt,
make sure to detach the tool socket. Failure to do so may
result in unexpected injury.
24. Do not give a strong shock to the switch panel or break it.
It may lead to a trouble.
25. Do not look directly into the light. Such actions could
result in eye injury.
Wipe
o
ff
any dirt or grime attached to the lens of the LED
light with a soft cloth, being careful not to scratch the lens.
Scratches on the lens of the LED light can result in
decreased brightness.
26. To prevent the battery power consumption caused
by forgetting to turn o
ff
the LED light, the light goes o
ff
automatically in about 2 minutes.
27. Resting the unit after continuous work.
28. Do not touch the protector, as it gets very hot during
continuous work.
29. Always use the tool and battery at temperatures between
-5
o
C and 40
o
C.
CAUTION ON LITHIUM-ION BATTERY
To extend the lifetime, the lithium-ion battery equips with the
protection function to stop the output.
In the cases of 1 to 3 described below, when using this
product, even if you are pulling the switch, the motor may
stop. This is not the trouble but the result of protection
function.
1. When the battery power remaining runs out, the motor
stops.
In such a case, charge it up immediately.
2. If the tool is overloaded, the motor may stop. In this
case, release the switch of tool and eliminate causes of
overloading. After that, you can use it again.
3. If the battery is overheated under overload work, the
battery power may stop.
In this case, stop using the battery and let the battery
cool. After that, you can use it again.
Furthermore, please heed the following warning and caution.
WARNING
In order to prevent any battery leakage, heat generation,
smoke emission, explosion and ignition beforehand, please
be sure to heed the following precautions.
1. Make sure that swarf and dust do not collect on the
battery.
○
During work make sure that swarf and dust do not fall on
the battery.
○
Make sure that any swarf and dust falling on the power
tool during work do not collect on the battery.
○
Do not store an unused battery in a location exposed to
swarf and dust.
○
Before storing a battery, remove any swarf and dust that
may adhere to it and do not store it together with metal
parts (screws, nails, etc.).
2. Do not pierce battery with a sharp object such as a
nail, strike with a hammer, step on, throw or subject the
battery to severe physical shock.
3. Do not use an apparently damaged or deformed battery.
4. Do not use the battery in reverse polarity.
5. Do not connect directly to an electrical outlets or car
cigarette lighter sockets.
6. Do not use the battery for a purpose other than those
speci
fi
ed.
7. If the battery charging fails to complete even when a
speci
fi
ed recharging time has elapsed, immediately stop
further recharging.
8. Do not put or subject the battery to high temperatures or
high pressure such as into a microwave oven, dryer, or
high pressure container.
9. Keep away from
fi
re immediately when leakage or foul
odor are detected.
10. Do not use in a location where strong static electricity
generates.
11. If there is battery leakage, foul odor, heat generated,
discolored or deformed, or in any way appears abnormal
during use, recharging or storage, immediately remove it
from the equipment or battery charger, and stop use.
12. Do not immerse the battery or allow any
fl
uids to
fl
ow
inside. Conductive liquid ingress, such as water, can
cause damage resulting in
fi
re or explosion. Store your
battery in a cool, dry place, away from combustible and
fl
ammable items. Corrosive gas atmospheres must be
avoided.
CAUTION
1. If liquid leaking from the battery gets into your eyes,
do not rub your eyes and wash them well with fresh
clean water such as tap water and contact a doctor
immediately.
If left untreated, the liquid may cause eye-problems.
2. If liquid leaks onto your skin or clothes, wash well with
clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
3. If you
fi
nd rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using the
battery for the
fi
rst time, do not use and return it to your
supplier or vendor.
WARNING
If a conductive foreign matter enters in the terminal of lithium
ion battery, the battery may be shorted, causing
fi
re. When
storing the lithium ion battery, obey surely the rules of
following contents.
○
Do not place conductive debris, nail and wires such as
iron wire and copper wire in the storage case.
○
To prevent shorting from occurring, load the battery in
the tool or insert securely the battery cover for storing
until the ventilator is not seen.
0000Book̲WR14DBDL2.indb 4
0000Book̲WR14DBDL2.indb 4
2019/03/20 11:22:05
2019/03/20 11:22:05
