HIKOKI WF 18DSL, Handling Instructions Manual

Page: 11 / 88

11
English
REGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe
the following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○ Lithium-ion batteries that exceed a power output of
100Wh are considered to be in the freight classification
of Dangerous Goods and will require special application
procedures.
CHARGER
Model UC18YRSL UC18YFSL
Charging voltage 14.4 V – 18 V
Weight 0.6 kg 0.5 kg
STANDARD ACCESSORIES
(1) Screw feed attachment ...............................................1
(Assembled in main body)
(2) No. 2 Plus Bit ...............................................................3
(Assembled in main body : 1)
(3) Sheet ...........................................................................3
(Assembled in main body : 1)
(4) Plastic case .................................................................1
(5) Battery cover ...............................................................2
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES
(sold separately)
○ Battery
(BSL1840) (BSL36..18)
Optional accessories are subject to change without notice.
Model WF18DSL
No-load speed 4200 min
-1
Capacity
Screw size 4 mm
Screw length 25 – 41 mm
Bit shank size 6.35 mm Hex.
Rechargeable battery
BSL1840: Li-ion 18 V
(4.0 Ah 10 cells)
Weight * (According to EPTA-Procedure 01/2014) 1.9 – 2.5 kg
* Depending on attached battery. The heaviest weight is measured with BSL36B18 (sold separately).
APPLICATIONS
○ Screw driving into indoor gypsum board.
BATTERY REMOVAL/INSTALLATION
1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Figs. 1 and 2 ).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2 ).
CHARGING
Before using the driver drill, charge the battery as follows.
1. Connect the charger’s power cord to a receptacle.
When the power cord is connected, the charger’s pilot
lamp will blink in red. (At 1-second intervals)
2. Insert the battery into the charger.
Firmly insert the battery into the charger, as shown in
Fig. 3 .
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in
red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals) (See
Table 1 )
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1 , according to the condition of the charger or the
rechargeable battery.
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
Power Output
2 to 3 digit number
SPECIFICATIONS
POWER TOOL
0000Book_WF18DSL_WE.indb 11 2019/03/11 14:23:12