English
39
GENERAL SAFETY INSTRUCTIONS FOR CORDLESS
DISC GRINDERS
— Check that speed marked on the wheel is equal to or greater than the rated speed
of the grinder;
— Ensure that the wheel dimensions are compatible with the grinder;
— Abrasive wheels shall be stored and handled with care in accordance with
manufacturer’s instructions;
— Inspect the grinding wheel before use, do not use chipped, cracked or otherwise
defective products;
— Ensure that mounted wheels and points are
fi
tted in accordance with the
manufacturer’s instructions;
— Ensure that blotters are used when they are provided with the bonded abrasive
product and when they are required;
— Ensure that the abrasive product is correctly mounted and tightened before use
and run the tool at no-load for 30 seconds in a safe position, stop immediately if
there is considerable vibration or if other defects are detected. If this condition
occurs, check the machine to determine the cause;
— If a guard is equipped with the tool never use the tool without such a guard;
<G3610DVE, G3610DVF>
—
When using an abrasive cutting wheel, be sure to remove the standard accessory
wheel guard and attach the wheel guard with side guard (sold separately)
(Fig. 17 on page 59);
<G3613DVE, G3613DVF, G3615DVE, G3615DVF>
—
When using an abrasive cutting wheel, be sure to attach the guard clip for cutting
wheel (sold separately) over the standard-accessory wheel guard.
(Fig. 18 on page 60);
— Do not use separate reducing bushings or adapters to adapt large hole abrasive
wheels;
— For tools intended to be
fi
tted with threaded hole wheel, ensure that the thread in
the wheel is long enough to accept the spindle length;
— Check that the work piece is properly supported;
— Do not use cutting o
ff
wheel for side grinding;
— Ensure that sparks resulting from use do not create a hazard e.g. do not hit
persons, or ignite
fl
ammable substances;
— Ensure that ventilation openings are kept clear when working in dusty conditions, if
it should become necessary to clear dust,
fi
rst disconnect the tool from the mains
supply (use non metallic objects) and avoid damaging internal parts;
— Always use eye and ear protection. Other personal protective equipment such as
dust mask, gloves, helmet and apron should be worn;
— Pay attention to the wheel that continues to rotate after the tool is switched o
ff
.
— Do not allow foreign matter to enter the hole for connecting the rechargeable
battery.
— Never disassemble the rechargeable battery and charger.
00Book̲G3610DVE̲ChS.indb 39
00Book̲G3610DVE̲ChS.indb 39
2022/08/26 16:18:36
2022/08/26 16:18:36
