English
25
VARIOUS TYPES OF CUTTING
1. Making grooves
NOTE
Depending on the type of material, uncut parts may be
produced around the material. Remove them with a
chisel, etc.
By adjusting the lower limit position so that the saw blade
stops at the desired depth
ⓐ
, the groove shown in
Fig. 55
can be formed.
After forming the groove with the saw blade, remove the
shaded area with a chisel, etc.
To form the groove
ⓐ
, it is necessary to adjust the lower
limit position of the saw blade to the distance
ⓑ
from the top
surface of the turntable to the saw blade.
Follow the procedure below to adjust the lower limit position
of the saw blade.
Make a groove with the saw blade
Remove with a chisel, etc.
Fig. 55
(1) Turn the stopper holder on the side of the head
backward. (
Fig. 56
)
Turn the stopper
holder backward
If the material
height is 20 mm
or more, depress
the stopper (B)
Fig. 56
(2) With the tip of the 6 mm knob bolt for adjusting the depth
of cut abutting hinge (A), turn the knob bolt to adjust
the lower limit position of the saw blade to distance
ⓑ
.
(
Fig. 57
)
Hinge (A)
Lower
the head
Adjust the 6 mm knob bolt
for adjusting the depth of
cut to set the lower limit
position to distance
ⓑ
.
Fig. 57
(3) If the height of
ⓑ
is 20 mm or more, you can tilt the
stopper (B) forward and abut the tip of the 6 mm knob
bolt for adjusting the depth of cut against the stopper (B)
to adjust it up to 60 mm. (
Fig. 56
)
NOTE
To use the stopper (B), tilt it forward and turn the stopper
holder backward.
2. Cutting materials that can easily deform such as
aluminum sashes
WARNING
●
Fix the material securely with the vise device.
If the material is not
fi
xed properly, it will deform and the
saw blade will become caught, causing the material to
fl
y
o
ff
and cause injury.
●
When using cutting oil (spindle oil), make sure that there
are no open
fl
ames in the area.
NOTE
○
When cutting an aluminum sash, apply cutting oil
(spindle oil) to the cutting edge of the saw blade to obtain
a clean surface easily.
○
When cutting aluminum sashes after processing wood,
remove the chips in the dust bag before starting the
work.
Thin materials such as aluminum sashes are easily
deformed, so if they are tightened with the vise device
without using an anchor plate, they will be deformed,
placing an excessive burden on the motor.
In addition, the material may rattle unexpectedly during
cutting, and an impact force may be applied to the saw
blade.
00Book̲C3607DRA̲ChT.indb 25
00Book̲C3607DRA̲ChT.indb 25
2020/07/20 11:36:16
2020/07/20 11:36:16
