English
18
4. Adjustment of the lower limit position of saw blade
WARNING
●
Adjust the lower limit position of the saw blade for the
185 mm tip saw [for aluminum sashes (sold separately)]
or when the outer diameter of the saw blade becomes
smaller after re-grinding of the cutting edge.
●
Adjust the lower limit of the saw blade carefully so that
the turntable is not cut with the saw blade and so that
there is no uncut area.
The saw blade is factory-adjusted so that the cutting edge
(lower limit position of the saw blade) stops 10 to 11 mm
below the top of the turntable.
Adjust the lower limit position of the saw blade using the
following procedure.
(1) Lower the head and push the tip of the 8 mm bolt for
lower limit position adjustment against hinge (A).
(
Fig. 29
)
(2) Turn the 8 mm bolt for lower limit position adjustment
with the 13 mm spanner to adjust the lower limit position
of the saw blade. (
Fig. 29
)
One turn of the bolt changes the position by about 2 mm.
8 mm bolt for
lower limit position
adjustment
Hinge (A)
Lower the head
Saw blade
Turntable
Fig. 29
5. Adjusting the right angle and bevel stop positions
When shipped from the factory, the head is adjusted so
that it stops at 0° (right angle), 45° left bevel and 45° right
bevel.
While holding down the head, loosen the clamp lever
and adjust in the following way.
0° (right angle) stop position (
Fig. 30
)
Adjust by turning the 8 mm bolt.
45° left bevel stop position (
Fig. 30
)
Adjust by turning the 6 mm bolt (A).
Tighten
Clamp lever
Set pin
8 mm bolt
(for 0° stopper) 6 mm bolt (A)
(for 45° left bevel stopper)
Indicator
(For right bevel scale)
Press at 0°
(right angle)
Loosen
Fig. 30
45° right bevel stop position (
Fig. 31
)
(1) Pull out the set pin in the direction of the arrow and tilt the
saw to the right.
(2) Turn the 6 mm bolt (B) to adjust the stop position.
(3) When the adjustment is completed, set the head to the
0° position and return the set pin to its original position.
NOTE
After checking and adjusting, tighten the clamp lever and
fi
x it.
Indicator
(For left bevel scale)
6 mm bolt (B)
(for 45° right bevel stopper)
Set pin
Pull out when
tilting the saw
to the right.
Fig. 31
WARNING
When loosening the clamp lever, be sure to hold down
the head.
The head may tilt suddenly, causing injury or damage to
the device.
00Book̲C3607DRA̲ChT.indb 18
00Book̲C3607DRA̲ChT.indb 18
2020/07/20 11:36:11
2020/07/20 11:36:11
