English
46
○
Do not use the main unit near equipment that generates electrical noise such as
generators. Electrical noise might cause faulty readings or operation on the digital display.
9. Cutting
operation
(1) As shown in
Fig. 17
the width of the saw
blade is the width of the cut. Therefore,
slide the workpiece to the right (viewed
from the operator’s position) when length
is desired, or to the left when length
is desired.
If a laser marker is used, align the laser
line with the left side of the saw blade, and
then align the ink line with the laser line.
(2) Once the saw blade reaches maximum
speed, slowly push down the handle and bring the saw blade in the vicinity of the material
to be cut.
(3) Once the saw blade contacts the workpiece, push the handle down gradually to cut into the
workpiece.
(4) After cutting the workpiece to the desired depth, turn the power tool OFF and let the saw
blade stop completely before raising the handle from the workpiece to return it to the full
retract position.
CAUTION
○
For maximum dimensions for cutting, refer to “SPECIFICATIONS” table.
○
Increased pressure on the handle will not increase the cutting speed. On the
contrary, too much pressure may result in overload of the motor and/or decreased
cutting e
ffi
ciency.
○
Con
fi
rm that the trigger switch is turned OFF and the power plug has been
removed from the receptacle whenever the tool is not in use.
○
Always turn the power o
ff
and let the saw blade stop completely before raising
the handle from the workpiece. If the handle is raised while the saw blade is still
rotating, the cut-o
ff
piece may become jammed against the saw blade causing
fragments to scatter about dangerously.
○
Every time one cutting of deep-cutting operation is
fi
nished, turn the switch o
ff
,
and check that the saw blade has stopped. Then raise the handle, and return it to
the full retract position.
○
Be absolutely sure to remove the cut
material from the top of the turntable, and
then proceed to the next step.
10. Miter cutting procedures
(1) Loosen the side handle and push the lever
for angle stoppers. Then, adjust the turntable
until the indicator aligns with desired setting
on the miter scale (
Fig. 18
).
Marking
(pre-marked)
Marking (pre-marked)
Fig. 17
Turntable
Indicator (A)
(For miter scale)
Side Handle
Lever
Miter Scale
Fig. 18
000Book̲C12LCH̲ChS.indb 46
000Book̲C12LCH̲ChS.indb 46
2018/03/27 17:48:22
2018/03/27 17:48:22
