English
45
8. Digital display panel (for C12LCH)
(
Fig. 14
and
Fig. 15
)
(1) Turning on the digital display
switch shows 0° for both miter and
bevel angle, regardless of main
unit angle.
(2) Align the main unit angle with the
tilt angle (0°) and miter angle (0°)
and hold down their reset buttons
for at least 0.2 seconds.
(3) Turning on the laser marker switch
while the digital display switch is on,
lights up the laser marker (On the
C12FCH, only the laser marker switch).
CAUTION
○
When operating the digital panel,
have the motor head section at the
top limit position and the blade
stopped.
○
If
the
fi
gure shown on the miter
angle digital display is di
ff
erent
from the positive stop angle (for
example, 45.0°
→
45.5°, 31.6°
→
32.0°)
then the positive stop has probably deviated slightly from its correct position. If
this happens, do as follows.
(1) Move the turntable left and right with
the side handle loosened, and set
the turntable to the correct position.
(2) If
the
fi
gures on the display and
positive stop still do not match, then
return the turntable to the 0° position.
Next move the turntable left and
right with the side handle loosened
as shown in
Fig. 16
. After setting it
to the correct position 0°, press the
reset button again.
NOTE
○
Before starting to cut, align the main unit to the miter angle 0° and the bevel angle 0° and
hold down the reset buttons for at least
0.2 seconds. If you press the digital display switch to ON without aligning the main unit to
0°, then the
fi
gures appearing on the digital display and the main unit angle will not match.
○
The laser marker will not light up if the digital display switch is turned o
ff
(only on C12LCH).
Miter angle
window
Miter angle
reset button
Back light ON/OFF
Bevel angle
window
Bevel angle
reset button
Fig. 14
Switch
(For laser marker)
Switch
(For Digital display)
(Only C12LCH)
Fig. 15
Miter angle
reset button
Side Handle
Fig. 16
000Book̲C12LCH̲ChS.indb 45
000Book̲C12LCH̲ChS.indb 45
2018/03/27 17:48:22
2018/03/27 17:48:22