Handheld Thermography Camera Pocket Series User Manual
5
Chapter 2 Preparation
2.1 Charge Device
Before You Start
Please make sure the battery is installed before charging.
Steps
1. Lift the cover of cable interface.
2. Plug in the cable, and connect the power supply to charge the
battery.
2.2 Power On/Off
Power On
Hold for over three seconds to turn on the device. You can observe the
target when the interface of the device is stable.
Note
It may take at least 30 s until the device is ready for using when you
power on it.
Power Off
When the device is turned on, hold for about three seconds to power
off the device.
2.2.1 Set Auto Power-off Duration
Go to Local Settings → Device Settings → Auto Off to set the automatic
shutdown time for device as required.
