NEW LEADER
HEADER
23
NL450C
Please Give Part No., Description
& Unit Serial No.
307306-B
Page Rev. A
INSTALLATION INSTRUCTIONS CONTINUED
SPINNER INSTALLATION
See
L5034G4
Spread Pattern Installation Instructions
at
www.highwayequipment.com
, then Support, then Operators
Manuals, then Fertilizer Spreader Manuals.
SPINNER SENSOR
The spinner sensor must be mounted under the right-hand spinner disc in holes provided. Rotate disc so one of the
cap screws is directly above the sensor. Position sensor 1/8-inch (.32 cm) or less below cap screw and tighten sensor
hardware. If the distance between the sensor and spinner cap screw is more than 1/8 inch (.32 cm), the sensor may
not get a good RPM reading. See
Spinner Sensor
parts list for illustration.
FILLING HYDRAULIC SYSTEM
NOTICE!
DO NOT attempt to run pump without first filling hydraulic oil reservoir and opening suction line
gate valve, or pump may be ruined.
Fill reservoir with hydraulic oil as specified in the
Lubrication & Maintenance
section of this manual. Be sure oil is
clean, free from dirt, water and other contaminants.
LUBRICATION
Lubricate all points requiring lubrication per
Lubrication & Maintenance Chart
in this manual.
OPER. & MAINT
.
INST
ALLA
TION
