HighLine Feed Chopper 1251, Operator'S Manual

Page: 19 / 37

Section 2 - Operating the CFR 1251 Feed Chopper
5. Begin to process a bale in the CFR 1251.
Note: If livestock is being fed, it is the
operator's responsibility to ensure
that the materials in the processed
feed mix are suitable. Some of the
wrapping material (twine, net wrap
or other materials) may be
discharged with the feed if the
wrapping materials are not
removed prior to processing.
6. The feed chopper will be driven by the
belt drive and chop the processed
material coming from the CFR1251
blower.
Should any vibration be detected
during the operation of the feed
chopper, immediately stop the
machine. Determine the source of
the problem and fix it before
resuming operation.
7. Drive ahead slowly while operating the
CFR 1251 /Feed Chopper.
Avoid discharging material in the
area of people and animals.
8. Disengage the chopper drive clutch when
done processing.
Do not place hands in the Feed
Chopper drive clutch area while
turning. Contact with the rotating
large pulley or clutch pin/plate can
cause serious injury.
To disengage the clutch:
-
Pull the clutch pin (2) out and rotate
until the roll pin is resting on the top of
the tab (3)
.
- Ensure the clutch pin (2) is out of the
engagement plate (1).
Pull Clutch Pin from the Engagement Plate
219152C2
Page 2-4