Installation & Adjustments
Predator SS Turntable Stretch Wrapper Operation Manual
Highlight Industries, Inc. ● 2694 Prairie S
W, Wyoming
, Mi 49519 ● 1
-800-531-2465
19
Relay 3:
Turntable/Film Carriage Stop
Relay 4:
Power Input
Relay 5:
Turntable Running
Fuse 1:
Carriage Motor (5 Amp)
Fuse 2/2A:
Power Input (10 Amp)
Fuse 3:
Turntable Motor (5 Amp)
Fuse 6:
Transformer Input (1 Amp)
Fuse 7:
Transformer Output (1 Amp)
LED 1 is ON:
Film Carriage Motor fuse is blown
LED 2 is ON:
Turntable Motor fuse is blown
LED 3/3A is ON:
Power Input fuse is blown
LED 7 is ON:
Cycle starts
LED 8 is ON:
Film Carriage is moving up
LED 10 is ON:
Film Carriage is moving down
LED 11 is ON:
Turntable is rotating
LED 15 is ON:
Start Button is pushed
LED 16 is ON:
Pause Button is pushed
LED 19 is ON:
Package Height Photo Sensor is unblocked
LED 23 is ON:
Carriage Max Up Limit Switch is not tripped
LED 24 is ON:
Carriage Max Down Limit Switch is tripped
LED 25 is ON:
Emergency Stop Button is not pushed
LED 26 is ON:
Turntable Home/Count proximity switch is blocked
LED 36 is ON:
Transformer Input/Output is blown
VR1:
Film Carriage Max Speed setting
VR2:
Turntable Max Speed setting
Replacing Microprocessor Card
1. Turn the disconnect switch to
OFF
position.
2. Removed the old microprocessor card by pulling all connectors off and loosening the
four mounting screws.
3. Install the new microprocessor card; connect all connectors and tighten the
mounting screws.
4. Turn the disconnect switch to
ON
position. The display should show “
- -
“. If not,
check all connectors and fuses again.
