Installation & Adjustments
Predator SS Turntable Stretch Wrapper Operation Manual
Highlight Industries, Inc. ● 2694 Prairie S
W, Wyoming
, Mi 49519 ● 1
-800-531-2465
17
Warning!
It is very important that the machine be leveled. Uneven floors will cause premature
turntable support roller failure.
Figure 5: Ramp Position for the Predator SS Low Profile
Power and Control Wiring Checks
1. Using a volt meter, check the AC voltage coming to the machine and insure the
proper voltage is present.
2. Make sure the Emergency Stop button on the operator panel is fully pressed in. Turn
the disconnect switch to the ON position. Power should be applied to the drive
board, operating touch-
panel, photoelectric sensors, switches, and LED’s
.
3. Press the Emergency Stop button. Make sure all machine power is completely
removed when the Emergency Stop button is depressed. Pull the Emergency Stop
button out to resume.
4. Open the electric control box. Make sure all machine power is completely removed
when the electrical control box is open. Close the electrical control box to resume.
5. Trip the carriage foot security bar. Make sure all machine power is completely
removed when the carriage foot security bar is tripped. Clear the bar to resume.
Warning!
Ensure that the Emergency Stop button light is ON when the button is pushed
in and OFF when the button is pulled out.
