High End Systems Dichroic Theatre Series, User Manual

Page: 55 / 60

Dichroic Theatre ™ User Manual ColorCommand Installation B - 5
B
Powering On
Caution: Do not power on the fixture until verifying that the line cord cap is
suitable for the power source in your location.
Warning: This equipment for connection to a branch circuit having a maximum
overload protection of 20 A.
Before powering on any ColorCommand fixture, complete the following:
• Make sure the lamp is installed as described in “Installing the Lamp” on page
B-1.
• Make sure the appropriate power cord cap is installed as described in “Installing
a Power Cord Cap” on page B-2.
• Make sure the rotary switch on all fixtures has been set as described in “Unit
Addressing” on page 2-3.
• Make sure ColorPower is linked appropriately to all fixtures in the fixture link as
described in “Setting up the Power Supply Link” on page 2-2.
At this point it is safe to connect ColorCommand fixtures to power.
Note: ColorCommand fixtures use a thermal protection relay. A ColorCommand fixture
must have a 4-pin XLR Color Changer cable connected or the lamp will not turn
on.
ColorCommand Maintenance
ColorCommand fixtures have no user-serviceable parts inside. If your fixture requires
maintenance, contact customer support (see “Contacting High End Systems®” on page
ii).
Cleaning the ColorCommand Lens
Warnings: Disconnect power and turn power switch off before servicing.
Equipment surfaces may reach temperatures up to 67° C (153° F).
Allow the fixture to cool before handling.
Clean the front ColorCommand lens using a mild glass cleaner (containing no ammonia)
and a soft, lint-free cotton cloth.
Replacing the ColorCommand Lamp
For information on replacing the lamp in a ColorCommand fixture, see “Installing the
Lamp” on page B-1.