background image

Collar Side Sub Assembly

Collar Rear 

Panel

Step 1 – Marking door panel for template 

(Fig 1/2)

•  Mark a vertical centre line on the rear of the door panel (a). 
•  Mark a horizontal line indicating the inside top edge of the  
  carcase for door overlap (b).
 
TIP:
 An allowance needs to be made for the door overlap with the top 
of the carcase e.g. for a 16mm thick carcase material and 3mm gap 
between the door panel and the bench top the horizontal line should 
be (16-3) = 13mm down from the top edge of the door panel (b). 

NOTE: If the unit is to be positioned higher in the cabinet trim the 
required amount off the top of the template. Trimming the template 
will adjust the mounting hole positions for both the collar and 
runner installation so they remain correctly aligned. 

The maximum amount that can be trimmed off is up to: 
CRL160 - 40mm.

Step 2 – Pre-drill door panel 

(Fig 2)

•  Align the door panel template with the lines as indicated and  
  mark the 6 mount holes (RED) through the template.
•  Drill a 2mm pilot hole at each of the 6 mounting locations.
 
TIP FOR FRAMED DOORS:
 3 screw locations are required for each 
door bracket. An alternative location for the top screw is accessible 
by removing the door bracket from the collar side. This should be 
used in framed door situations and should be inserted after step 5  
of the Installation Instructions.  Refer overleaf for instructions.

Step 3 – Install collar side sub-assemblies 

Refer to Fig. 3  
3.1 - Position collar side assemblies. 
3.2 - Secure each using 12mm Surefix screws provided. 

Step 4 – Install collar rear panel on to collar sides 

Refer to Fig. 3  
4.1 - Position collar rear panel as shown.  
4.2 - Secure using 6g x 12mm self-tapping screws.  
NOTE: do not use impact driver or high torque setting. 

CONTENTS

 OF

 CAR

TON

 ONE

:

Left hand collar 

assembly

Right hand  

collar  

assembly

Collar rear panel

Right hand  

collar  

assembly

Left hand  

collar  

assembly

Concelo Laundry CRL160D  

Collar Assembly Instruction Sheet

Read all instructions before installing this bin unit.  
Failure to install the bin correctly may void warranty.

FIG.3

FIG.1

(a)

(b)

FIG.2

1 of 4mm 

Allen Key

6 of 12mm  

Surefix Screw

6 of 6G x 12mm  

Self-tapping 

Screw

Reviews: