Position and secure handles for ease of operation. Measure down approximately 36”
(915mm) from the panel top to the top of the handles.
Install legs with the 1 1/2” x 5/16” washer on the inside of the Rails and the Nylon
washer on the outside. Tighten nut to have a small amount of friction when leg
assembly is rotated from the up to down position.
Pre-drill and screw leg stops in position shown on Drawing 17. NOTE: Leg stop
should hold leg in horizontal position as shown. Use #8 x 3/4” screws.
Install leg connector rod between legs and secure with 1/4” x 1 1/4” Hex head bolts
and star washers. Assemble modular sections of leg connector rod. Be sure they are
securely tightened so not to loosen and wobble in use. See pg. 20 for direction.
Install mattress and secure with previously installed Velcro straps. Cut the excess
Velcro to leave about 12” (300mm) of overlap.
Snap the powder coated steel mechanism covers in place - secure with #8 x 1 1/4”
black wood screws through the standoff on the backer plate.
Follow up to Initial Assembly
Level or square problems of Bed Face fit to Cabinet. Nudge base of Cabinet at the
floor level - or do shims under the Side Panels.
Feel of Stiffeners is evident through mattress. Add foam panels or layers of flat
corrugated cardboard between stiffeners.
If bed is too heavy to operate easily or slams shut: remove Bed Face Panel and add
or subtract springs. At this time you may decide to use one more or less spring(s) on
the left or right side Lift Mechanism.
1.
2.
3.
4.
5.
6.
STEP 8: Install Handles - Legs - Mechanism Covers - Mattress
Bed Closed Position
Bed Face Panel
Floor
Side Rail
1/4”-20 x 1 1/4” Bolt
Rubber Foot
Segmented Steel Leg Rod
(threaded together)
Steel Leg
Star Washer
Bed Open Position
Angle Bracket
Leg Stop
3/4” (19)
Thick End Rail
O.C. 2 5/8”
(66.6)
Drawing 16.
Drawing 17.
O.C. 1 3/8”
(35)
Leg Pivot Hole
19.
