X8
X8
X16
X4
X8
04b
04a
X
1”
(25mm)
© 1995-2009 Energy Saving Products Ltd.
Hanging Strap Kit
The Hanging Strap Kits are designed to suspend a
horizontal or vertical fan coil. The nylon straps will absorb
most of the vibration generated by the fan coil system,
eliminating any sound transfer. Alternative hanging
methods may be used, e.g. Reddy Rod or Unistrut.
Hanging Fan Coil Unit Only
Attach the metal flanges to the four facing corners of
the fan coil unit
(Fig. 02)
.
Cut the nylon straps to the desired length (4”/
102mm
or
more) and drill a 3/8”
(7mm)
hole 1”
(25mm)
from the end of
each nylon strap.
(Fig. 03)
Secure the nylon straps to the joist or support. It may be
necessary to install a support across the joists to properly
fasten the Nylon Straps
(Fig. 05)
. The Nylon Straps are
always installed in a vertical position; they should never
be installed at an angle. It is acceptable to put a 90º twist
in the Nylon Straps
(Fig. 05a)
, do not exceed 90º.
Fig. 05 - Install Support if Needed
Fig. 05a - 90° twist
Using the “L” brackets provided with the cooling coil,
attach the module to the return side of fan coil unit, using
two sided tape for air seal between units. Assure that
drain controls are on the bottom
(Fig 06),
and that no
screws puncture the drain pan or coil. The
WCM and WM
chilled water coils are a horizontal airflow with a vertical
position of the coil while the
RPM-E
is also a vertical coil
with multiple air flow capabilities. See the corresponding
manual included with the coil for detailed installation
instructions.
Fig. 02 - Attach flanges to Unit
Slide the 1
1
⁄
4
”
(32mm)
bolt into the hole of the metal
flange then into the nylon strap, secure with washer
and nut. Repeat this at each end of the nylon straps
(Fig. 04a,04b)
.
Fig. 03 - Cut Hole in Straps
Fig. 04 - Attach Flanges to all Straps
Lift the fancoil unit and slide the bolt into the metal
flange located on the unit through the nylon strap, and
finish with the washer and nut.
Fig. 01 - Hanging Strap Kit Components
BOLT
5/16”
WASHER
(7.9
mm
)
1/4” LOCK
NUT
(6.4
mm
)
5/16” X 3/4”
SELF TAPPING
SCREW
(12.7
mm
)
METAL
FLANGE
24” NYLON STRAP
X8
Fig. 06 Attach Cooling Coil to Fan Coil Unit
Attach the metal flanges to the four facing corners
of the fan coil and cooling coil assembly.
After attaching the metal flanges, follow the same
steps for hanging fan coil unit only.
Hanging Fan Coil Unit with Cooling Coil
Hanging the
Hi-Velocity Unit
Module FCP
Hi-Velocity Fan Coil Placement (2/2)
Module FCP Hi-Velocity Fan Coil Placement (2/2)
