HHP IMAGETEAM 4600, User Manual

Page: 42 / 234

2 - 12 IMAGETEAM™ 4600/4800 User’s Guide
RS-232 Receiver Time-Out
The unit stays awake to receive data until the RS-232 Receiver Time-Out
expires. A manual or serial trigger resets the time-out. When an RS-232
receiver is sleeping, a character may be sent to wake up the receiver and reset
the time-out. A transaction on the CTS line will also wake up the receiver. The
receiver takes 300 milliseconds to completely come up. Change the RS-232
receiver time-out by scanning the bar code below, then scanning digits from the
inside back cover of this manual, then scanning
Save. The range is 0 to 300
seconds. Default = 0 seconds (no time-out - always on).
RS-232 Handshaking
RS-232 handshaking is a set of rules concerning the exchange of data between
serially communicating devices.
If using RTS/CTS handshaking, the imager issues an active RTS signal to the
receiving device. The imager waits to send its data until it detects an active CTS
signal from the receiving device. The imager then sends its data while checking
the CTS signal before the transmission of each data character. If an inactive
CTS signal is detected at any time, the imager halts transmission until it detects
another active CTS signal. When the imager has finished transmitting data, it
issues an inactive RTS signal to the receiving device.
Default = RTS/CTS Off,
XON/XOFF Off, and ACK/NAK Off.
RS-232 Receiver Time-Out
RTS/CTS On
* XON/OFF Off
* RTS/CTS Off
XON/XOFF On
ACK/NAK On
* ACK/NAK Off