HHP IMAGETEAM 4600, User Manual

Page: 51 / 234

IMAGETEAM™ 4600/4800 User’s Guide 3 - 5
Low Power Time-Out Timer
Scan the Low Power Time-Out bar code to change the time-out duration (in
seconds). Then scan the time-out duration (from 0-300 seconds) from the inside
back cover, and
Save. Default = 120 seconds.
If the unit remains idle during the low power time-out interval, the unit goes into
low power mode. Whenever the trigger is enabled, the low power time-out timer
is reset.
Note: This time-out does not begin until the imager time-out setting has expired.
Scan Stand Mode
When a unit is in Scan Stand mode, it remains idle as long as it sees the Scan
Stand symbol. (See
Scan Stand Symbol that follows.) When a different code
is presented, the Imager is triggered to read the new code.
Note:The imager automatically adjusts the illumination LEDs to the lowest light
level possible to maintain a good lock on the Scan Stand symbol. When a
symbol is presented, the imager’s light levels adjust to the saved setting (see
LED Power Level on page 3-9).
Scan Stand Symbol
Note: Scan Stand mode does not work when scanner is programmed for the
laser emulation interface.
Low Power Time-Out
Scan Stand Mode