12
EN
(3) Setting up the dehumidifier
The dehumidifier should be operated in a closed room in order to achieve its best performance. Close all
openings to other parts of the building, such as windows and doors, so that the humid air cannot mix with
the air in the areas to be dried. Open and close doors as far as possible. A so-called closed drying
chamber is produced. A number of units should be used to permit a triple air change.
Within the drying chamber, the air should be free to circulate. Open doors inside and employ air blowers
in order to achieve a good air circulation in all parts.
Set up the dehumidifier in such a way that the air flow is not restricted by the inlet and outlet. Do not set
up near loose material, such as curtains.
Normally the dehumidifier is set up in the middle of the room. In order to dry a certain point, the
dehumidifier has to be set up in such a way that the air is directed on to the wet area and the hot, dry air
passes over. The opening should be at least one meter away from the wall.
HEYLO dehumidifier heat the air which is drawn from the humidity. In smaller room, the temperature may
increase considerably. Room temperatures of between 20 deg. and 27 deg. C offer good drying
conditions as a rule. The room temperature should not exceed 38 deg. C and should not go below 1 deg.
C as otherwise the dehumidifier no longer operates (cf. chapter (7).
(4) Putting into operation for the first time
Unpacking
The dehumidifier of the DT series is delivered individually packed. The packaging should be removed as
follows:
Keep the cardboard straight. Do NOT turn the packaging upside down (it must be possible to read the
writing). Using scissors or a similar tool, cut through the straps holding the bottom at the packaging and
pull off the packaging upwards. Now remove the polystyrene transport protection. Then lift off the device
from the lower transport protection and put it on the floor. Finally, please remove the plastic film.
Switching on the device for the first time
In order to be able to switch the unit on, it has to have been placed in correct, straight position for at least
two hours.
(5) Operation of the dehumdifier
Operate the dehumidifier in upright position only.
Connect the unit to a grounded power outlet with the correct voltage (230 Volt / 50 Hz) and 16
amps fuse.
Check operational readiness
Check whether the condensate tank has been set in correctly.
Summary of Contents for DT 550
Page 7: ...7 DE 9 Ersatzteilliste ...
Page 9: ...9 DE 10 Schaltplan ...
Page 15: ...15 EN 9 List of spare parts ...
Page 17: ...17 EN 10 Wiring diagram ...