Required TEL Locations
The Aruba 7005 Mobility Controller requires a minimum of 4 TELs to be applied as follows:
To Detect Opening the Chassis Lid
•
Spanning the front left side and right rear corners of the chassis lid where it meets the chassis bottom, as shown
in Figures 7 and 8 (Labels 1 & 2).
To Detect Access to Restricted Ports
•
Two labels spanning the RJ-45 and mini-USB serial ports, as shown in figure 8. Press down on this label to
ensure that it adheres to a sufficient area of the front bezel. The RJ-45 port is raised relative to the bezel so there
will be some air gap under the label in this area. However, the air gap should not be larger than 2-3mm.
Figure 7 Required TELs for the Aruba 7005 Mobility Controller – Bottom
Figure 8 Required TELs for the Aruba 7005 Mobility Controller – Front
34
|
Aruba 7XXX Series Controllers FIPS 140-2 Level 2 Security Policy