20
Fig. 16. Attaching lifting column (viewed from above)
to example desk top support
4. Now tighten the four screws on each lifting column to
7 Nm max. using a hex driver.
5. The desk top can now be fitted.
5. Transportation and installation
5.2.1 Installing lifting column
Fit the lifting column to the skid and desk top support. To do this
you will need the following tools:
· 1 x hex driver,
· 8 x M6 hexagon socket head screws per lifting column.
To install the lifting column proceed as follows:
1. Connect a skid to a lifting column by means of four hexagon
socket head screws.
Fig. 15. Attaching lifting column (viewed from below) to
example skid
2. Now tighten the four screws on each lifting column to
7 Nm max. using a hex driver.
3. Now connect the requisite lifting columns to the desk top
support by means of four hexagon socket head screws per
lifting column.
i
Note
Use M6 screws of appropriate length, paying
attention to maximum screw length. The screw
must be driven into the column by 8 - 12 mm.
i
Note
An even standing surface with a sufficient load
bearing capacity is essential for setting up the
height adjustable desk in a proper and safe
manner. Any unevenness in the standing surface
must be evened out.
i
Note
If lifting columns are replaced in a system, it is
imperative to return the lifting columns to facto-
ry settings first (see Section 7.5.9) and perform a
manual reset (see Section 7.4.4).
