21/34
6.5
Lid lock control
The lid can be opened when the rotor is at standstill and the key is pressed. The
solenoid on the lid lock remains energized for three seconds.
With this kind of lid lock control, the jumper for the lid lock control on the power board
(see below) must be plugged.
Jumper für Verschlußansteuerung
Jumper for lid lock control
Leistungsteil
Power board
Unwuchtschalter
Imbalance switch
Deckelverriegelung
Lid lock
Motor
Übertemp. -schalter
Overtemp. switch
Übertemp.-sicherung
Overtemp. fuse
Bremswiderstand
Brake resistor
S402L
S402N
L1
N
S402P
A 1
S404
S503
S501
2 3 4
1
S405
1
2
3
4
S502
S401
UR US UT
1
2
3
4
5
n. c.
6.6 Imbalance
switch-off
The permissible imbalance is specified for rotor E1624 by the indication of the
difference in weight of opposite rotor positions.
When having a difference in weight within the range of 7g to 15g during run-up, the
drive has to switch off before reaching 1500 RPM.
The imbalance switch-off is adjusted by changing the distance of the imbalance switch.
With a test run with the indicated differences in weight the imbalance switch-off will be
checked.
Adjusting the imbalance switch:
•
Loosen both screws at the angle bracket of the imbalance switch on the outer part of
the housing floor until you can shift it.
•
Set the permissible imbalance by shifting the angle bracket.
•
Tighten both screws at the angle bracket of the imbalance switch again.
•
Check the imbalance switch-off with a test run.
