Hettich AvanFit YOU 300, Operating And Assembly Instructions Manual

Page: 19 / 96

19
6. Start up
6.2 Starting up for the first time
Before starting up the machine for the first time, observe the
following:
• Check to make sure the machine has been installed in ac-
cordance with the regulations specified!
• Make sure the machine stands firmly!
• Check to make sure that no foreign objects (tools, construc-
tion material etc.) have been left in the area of the machine
from the assembly process!
• Adjust the machine's working height in accordance with
ergonomic guidelines.
• Check whether the operating voltage is the same as the
voltage shown on the motor rating plate and whether mo-
tors or other drive units are being driven in the correct feed
direction!
• Check the hoses as well as the pneumatic system's hose
connections!
• Make sure that moving components can move without
obstruction into the spaces they require and that the safety
distances are observed.
6.2.1 Checking for proper working order without material
The machine must only be put into operation by trained and
qualified personnel.
Before putting into operation with material, the machine must be
allowed to empty to let machine parts run in under low load. Du-
ring this period, the moving parts in particular should be checked
for excessive heat buildup and noise. An excessive buildup of
heat is an indication of incorrect alignment or use of the wrong
lubricants - this must be rectified.
6.2.2 Checking for proper working order with material
Once the machine has been checked without material and run
in, it is put into operation with components under operating
conditions.
Note
The machine must only be put into operation for
the first time by a person instructed / authorised
to do so by the manufacturer / distributor or un-
der the manufacturer's / distributor's supervision.
i
Note
As you did on starting up without material, listen
for unusual noises and check to see if there is
any heat buildup.
i
en