1
2
3
The bag of wood pellets must not be placed on
the rubber seal when filling pellets in the tank.
Open the pellet lid.
5
1. OPERATING INSTRUCTIONS
Before using
Before using the pellet stove, make sure
that the installation requirements have been
complied with. See page 24.
Filling of wood pellets
Remember to close the pellet lid, otherwise the
lid sensor will be activated and the wood pellets
will not be fed through.
First firing
The stove paint is fully cured from the factory,
but a minor unpleasant odour could still arise.
Lighting the stove
1. Check that the burn pot is in place in the
frame. See page 13.
2. Roll out the room temperature sensor which
is located on the back of the stove. Make
sure that it does not come into contact with
cold or hot surfaces.
3. Connect the stove to the mains using the
supplied cable.
4. Set the desired settings using the display.
See page 6.
5. Feed the pellets through as mentioned
below.
6. Start the stove. See page 7.
Manual pellet feeding
Before starting your stove for the first time or if
it has run out of wood pellets, the pellet feeder
may be completely empty and therefore ignition
may fail. To avoid this, on the display you can
manually fill the pellet feeder before starting the
stove.
Follow these steps to enable pill feeding:
Press
and then select
.
Activate manual pill feed by sliding the button
to the right. When the bottom of the burn pot
is covered with wood pellets, the pellet feed is
deactivated again and the burn pot is emptied
of pellets to ensure that the ignition sequence is
performed correctly.
Important
The burn pot must be empty
Of wood pellets before start-up.
Wood pellets
Only burn wood pellets in the pellet stove, Heta
recommends 6 mm wood pellets.
