HERZ ETKF+
Page 10
Mounted condition:
Once mounted, the wall The can easily be pulled of the mounting plate and out of the
frame.
• Pull sideways at the frame to remove the electronic unit of the wall together with the frame.
Replacing batteries:
• Turn the wall the over to remove or insert the batteries.
• After removing the old batteries, please wait approx. 60 seconds.
• Insert two LR03/ micro/ batteries in the battery compartments (making sure that you insert them
the right way round).
• Put the electronic unit back into the frame (B).
The empty battery symbol (
) indicates that the batteries need to be changed. If, in
addition, a "V" or "S" are displayed, the batteries of a taught-in ETKF+ (V) or window
(S) have to be replaced.
Never recharge standard batteries. Doing so will present a risk of explosion. Do not throw
the batteries into a fire! Do not short-circuit batteries.
Used batteries should not be disposed of with regular domestic waste! Instead,
take them to your local battery disposal point.
Mounting:
You can either use screws or adhesive strips to mount the wall the to a wall in the frame
supplied or integrate it into an existing switch.
Adhesive strip mounting:
• Choose a site for installation. The surface on which you are mounting the room thermostat must
be clean, dry and free of grease.
• For mounting of the assembled wall the, attach the adhesive strips to the back side of
the mounting plate (A). You should be able to read the letters on the back side (according to
figure).
• Remove the protective film from the adhesive strips.
• Press the assembled wall the with the back side to the wall in the position where it
should subsequently be attached.
