H8 DSP
Digital Interface Processor
User’s manual
8
31
2.
Save Setup:
it enables the storage of the entire
H8 DSP
configuration in a file
(e.g. “H8Config.dip”) that you can subsequently load into the
H8 DSP
through
the
Load Setup
function. This feature is available both in
TARGET
and in
OFFLINE
modes.
3.
FINALlZE to H8 DSP:
it enables the loading of all the
parameters selected while configuring the
H8 DSP
into the
internal memory, allowing it to work without being connected to a PC.
When selecting the
Finalize to
H8 DSP
function, the software
notifies you that the data previously saved to the
H8 DSP
will be overwritten.
-
Select
YES
to load the data.
-
Select
NO
to interrupt the process.
WARNING:
Before disconnecting the
H8 DSP
from the PC or each time that you exit the PC Software after modifying
the system configuration, always run the
Finalize to H8 DSP
procedure. If you do not follow these instructions,
all data entered will be lost and the device will use the previous settings.
4
Synchronize: PC -> H8 DSP, PC <- H8 DSP
These functions synchronize the PC with the
H8 DSP
.
If a dialog box like the one on the right appears, it means that for some reason
communication between the PC and the
H8 DSP
has been interrupted.
To restore the communication, select:
•
PC -> H8 DSP
. The PC loads the settings selected so far into the
H8 DSP
.
•
PC <- H8 DSP
. The PC loads the settings that have been previously stored
in the
H8 DSP
WARNING:
This operation cannot guarantee that data are always retrieved.
If the operation is not successful, you need to:
1.
exit the
H8 DSP
software;
2.
turn the
H8 DSP
off;
3.
turn the
H8 DSP
on;
4.
launch the
H8 DSP
software again.
Synchronization will be restored but the selected settings will be lost
5
Check for updates:
it enables the connection to the website
www.bitdrive.it
, and checks if any software / firmware
updates to the
H8 DSP
and DRC are available, in order to update the devices you are using. To perform this
operation, your PC has to be connected to the internet
6
Check for Updates on startup:
when enabled the availability of new firmware/PC Software updates is checked
automatically each time you start the program.
7
Register product:
This function requires an internet connection and opens the default browser to the page for
registering the product and creating a personal account in the “bit Drive” portal. This operation only needs to be
performed once; then you can access your account through the Login Account.
8.
Update Firmware:
select to update the
H8 DSP
firmware
(see 9.3).
9.
Reset Default Answer:
it restores the display of warning messages if they have
been disabled by checking
“Don’t show me again”.
10.
Restore Factory Defaults:
entirely resets the
H8 DSP
back to its default settings,
cancelling all data previously saved in the processor.
11.
Credits:
it shows information about the
H8 DSP
software in use.
12.
Exit:
exits the PC software.