Select XLS Towel heater
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY
This appliance must be disconnected from its power source during installation or service activities and when
replacing.
The Select XLS towel heater is equipped with a sensor providing temperature control of the unit and the
surrounding area. Nevertheless the panel surface can rise to 90
°
C / 194
°
F (depending upon input voltage) and
must not be operated in locations where people can fall or become immobile next to the heater.
The Select XLS towel heater has internal safety thermal cut out sensors. However, in order to avoid overheating
and potential fire hazard,
DO NOT
cover the entirety of the heater. The lower section of the heater only may
have towels placed against it using the rail provided. DO not cover the upper (hotter) heating surface of the
heater under any circumstances.
DO NOT
touch the heater when in use. The upper portion of the heater has a surface temperature of around
90°C / 248°F (depending upon input voltage) and prolonged contact with this section of the heater will cause
burns and injury.
DO NOT
operate the heater if the cord or plug is damaged or after the heater malfunctions, or if it has been
dropped or damaged in any manner. Check each heater for damage before installation. Make sure that the
heater itself, the plug (if applicable) and the cable are free of any visible signs of damage. If the cord is damaged
the appliance must be sent for repair to an authorised Herschel Dealer.
This heater must only be used for the heating of people or buildings. The heater is not to be used by children or
persons with reduced physical, sensory or mental capabilities, or lack of experience or knowledge. Children
should be kept away and should not be left unsupervised around the unit.
DO NOT
use outdoors.
All operators should only switch on/off the appliance provided that it has been placed or installed in its
intended operating position in accordance with these instructions. Children must not plug in, switch on or
regulate the appliance or perform user maintenance including cleaning.
Herschel panels are designed for use with an AC voltage between 220-240 volts, 50 Hz AC. If your supply voltage
exceeds 240 Volts do not use the heater and refer to your local dealer. Failure to adhere to this will void the
warranty.
The heater must be mounted on a non-flammable surface.
SAVE THESE INSTRUCTIONS.
IMPORTANT SAFETY PRECAUTIONS
Failure to observe these instructions will invalidate the warranty.
Do not disassemble. No user-serviceable parts inside.
ENGLISH
