HERON 8896670, Translation Of The Original User Manual, Page: 42 / 51

83 82
EN EN
11
16
15
Fig. 3 (continued)
Fig. 3, position-description
1) Fuel tank with cap
2) Fuel supply open/close valve
3) Engine shut off button
4) Handle with engine starting cord
5) Choke lever
6) Throttle lever (engine rpm)
7) Air filter cover
8) Carburettor
9) Carburettor mud bolt
10) Oil drain bolt for removing oil from engine oil pan
11) Oil cap for pouring motor oil into the engine oil pan
12) Engine shaft
13) Adjustable directional exhaust cover
14) Spark plug connector
15) Electronic sensor for detecting the oil level in the oil pan
16) Year of manufacture (first two digits) and engine's
serial number
IV. Installing the engine
•
WARNING
y
The engine may only be installed into a respective piece
of equipment by a professionally trained person able to
evaluate and ensure the performance of all necessary
tasks for its safe installation and operation of the
powered equipment.
•
WARNING
y
The engine must be installed into the powered equip-
ment before being started.
V. Before starting the
engine
•
WARNING
y
Prior to starting the engine, carefully read the entire
user's manual before first use and keep it with the
product so that the user can become acquainted with
it. If you lend or sell the product to somebody, include
this user's manual with it. Prevent this user's manual
from being damaged. The manufacturer takes no
responsibility for damages or injuries arising from use
that is in contradiction to this user's manual. Before
using this engine, first acquaint yourself with all the
control elements and parts as well as how to turn it
off immediately in the event of a dangerous situation
arising. Before using, first check that all parts are firmly
attached and check that no part of the engine, such as
for example safety protective elements, is damaged or
incorrectly installed, or missing. Do not use an engine
with damaged or missing parts and have it repaired or
replaced at an authorised service centre for the Heron®
brand - see chapter Servicing and maintenance, or
the website address at the introduction to this user's
manual.
III. Parts and control elements of the engine
•
ATTENTION
y Both engine models have the same control elements and components. The description of components and control
elements is provided for the engine Heron® 8896670.
Note:
y The models may differ in their appearance and exhaust pipe cover design (fig. 3, position 13) compared to the shown
design. On description fig. 3, position 13, the exhaust fume outlet is fitted with an adjustable directional cover thanks
to which the user can direct the exhaust fumes as necessary, after screwing it out in advance. In the event that the
directional exhaust cover is supplied separately, remove the existing exhaust hole fitting and attach the directional
cover pointing in the required direction.
7
4
6
5
1
2
3
12
11
10
13
14
9
8
Fig. 3