9
1.9
Circulation pump
the flow-head performance curve available for the heating
system is shown in the graph below.
RESiDUaL HEaD (mbar)
0
0
800
1000
1200
600
400
200
100
200
300
400
500
600
FLOw (l/h)
Fig. 4
the flow-head performance curve available for the remote hot
water tank coil is shown in the graph below.
RESiDUaL HEaD (mbar)
0
0
800
1000
1200
600
400
200
100
200
300
400
500
600
FLOw (l/h)
Fig. 5
m
CaUTiON
the appliance is equipped with a by-pass which en-
sures water circulation in the boiler when the ther-
mostatic valves or cocks are used in the system.
1.10 Control panel
1
2
Fig. 6
1
FUNCTiONaL bUTTONS
y
If pressed once or more than once for at least 1 second
during normal operation, this button allows the user
to change the boiler operating mode in a cyclical se-
quence (stand-by – summer – Winter).If the boiler is
experiencing a fault which can be reset, it allows boiler
operation to be unblocked.
r
during normal operation, pressing the button displays
the domestic hot water set point which can be betwe-
en 10 and 60°C. In "parameter setting", the user can
scroll through the parameter index (decreasing) by
pressing this button.
t
during normal operation, pressing the button di-
splays the heating set point which can be between 20
and 80°C. In "parameter setting", the user can scroll
through the parameter index (increasing) by pressing
this button.
<
during normal operation, pressing this button allows
the user to reduce the heating or dHW set point on
the basis of the selection made previously. If there is
a Remote Control (open therm), after having selected
the heating button, the user can modify the incline of
the climatic curve (decreasing it) by pressing the but-
ton (-). In "parameter setting/display", the user can
modify the parameter setting or value (decreasing) by
pressing this button.
>
during normal operation, pressing this button allows
the user to increase the heating or dHW set point on
the basis of the selection made previously. If there is
a Remote Control (open therm), after having selected
the heating button, the user can modify the incline of
the climatic curve (increasing it) by pressing the but-
ton (+). In "parameter setting/display", the user can
modify the parameter setting or value (increasing) by
pressing this button.
c
Programming connector cover plug.
