Connecting the Cleaning Solution to the Washer
Placing Equipment in the Gun Washer
1)
Disconnect the drain hose from the flare connector on the
To clean guns not mentioned here, use the long or short
bottom of the tank.
stem supports as needed (see pg.15). For questions or
2)
Insert the drain hose and siphon tube into a fresh 5 gallon
adapter kits contact your paint gun washer distributor.
cleaning solution can and secure the plug in the opening.
3)
Reconnect the drain hose and tighten.
Siphon Feed Guns
4)
The can must contain at least 4 gallons of solution to pump
Place the gun siphon tube on the short stem support.
properly. Use a high quality cleaning solution.
Preparing the Equipment to be washed
Gravity Feed Guns (HVLP)
1)
Remove paint cup or paint line and the air line from the
Place the long stem support over the short stem
paint gun.
support. Place paint inlet of gun on long stem support.
Place the air cap assembly over the air inlet of the gun to
2)
Drain excess paint from cup and gun.
prevent solution from entering the passage.
3)
Remove all gauges and regulators.
Pressure Feed Guns
Place long stem support over the short stem support.
4)
Lock the gun trigger in the open position by placing the
Place paint inlet of gun on long stem support.
trigger lock around the gun handle and trigger (see fig.10).
Pots and Cups
CAUTION
Place a pot or a cup on the 4-armed platform.
All pressure gauges must be removed before placing the
equipment in the gun washer to avoid damaging the
gauges.
Operation
Page 9 of 19
Gravity Feed
Gun (HVLP)
Air Cap
Assembly
Paint Cup
Long Stem Support
Paint Cup
Siphon Feed Gun
Short Stem Support
Trigger Lock
Pressure Feed Gun
Paint Cup
fig.10
Page 9 of 19
