Operating the Gun Washer
1)
Make sure wire trigger locks and other accessories
5)
If the lid is opened prior to the end of the timing cycle, the
are inside the gun washer tank.
safety air cutoff switch will stop the gun washer. The
gun washer will start again when the lid is closed if time
2)
Place equipment in the tank according to the diagrams
remains on the timer.
shown in fig.10.
Note: Open the lid slowly to minimize vapor escape.
3)
Close the gun washer lid.
6)
Remove the equipment from the gun washer and wipe off
4)
Turn the timer knob clockwise 90 degrees to start the gun
any remaining cleaning solution.
washer. The gun washer will run for 90 seconds. Turning
the timer knob less than 90 degrees will reduce the timing
cycle. Paint equipment will clean in 60 to 90 seconds.
1)
Drain excess paint from cup or pot before placing in gun
washer.
2)
Drain paint sludge from 5 gallon can weekly.
Do this after a weekend so the sludge has settled.
Access the 5 gallon can by removing the black hose from
the nylon plug and remove the plug from the can
Preventive Maintenance
Operation
Filter/Regulator
#T17M
Page 10 of 19
the nylon plug and remove the plug from the can.
Pour the solution into a second container and drain the
sludge into a disposal container. Refill can from the
second container and add solution to reach the
4 gallon minimum, or 3" from the top of can.
Clean siphon tube with cloth and brush to remove residue.
3)
Remove the filter bowl and check the filter inside the
regulator for excess buildup approx. every 6 months.
4)
Change cleaning solution completely when objects being
cleaned become tacky to the touch.
5)
Clean inside of tub and internal manifold.
Do not change the setting of the filter/regulator.This could
damage the filter/regulator or pump
CAUTION
Filter/Regulator
#T17M
Filter
#1001382
Filter Bowl
Page 10 of 19
